Installation guide
From Psychosynth
m (→Dependencies) |
m (→Dependencies) |
||
| Line 34: | Line 34: | ||
</pre> | </pre> | ||
| − | then continue with the following installation | + | then continue with the following installation (first check that file configure.ac has commented this line: PACKAGE_DATA_DIR="./data") |
<pre># autoreconf</pre> | <pre># autoreconf</pre> | ||
| Line 42: | Line 42: | ||
<pre># make</pre> | <pre># make</pre> | ||
| − | and then run the program | + | and then run the program simply typing psynth3d, if the program gives you the output: ''[/alsa] WARNING: Could not write to device. (Broken pipe)'' change the audio to oss in config menu. |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | [/ | + | |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
== Installing == | == Installing == | ||
Revision as of 23:35, 27 October 2008
First of all you must get a copy of the sources of this program. Go to the download section if you do not have them yet. Note that this document is only to install from the sources -if there is a binary package for your distribution, use that instead.
Dependencies
Then, to try the software you will need these third party libraries and programs:
|
|
In Debian and Ubuntu you can install all those dependencies with the following command. Anyways, I suggest installing liblo from the original sources because the version in the repositories is outdated and contains a bug:
apt-get install automake libtool libogre-dev libois-dev libcegui-mk2-dev libasound2-dev libjack-dev liblo0-dev libsndfile-dev libxml2-dev libsoundtouch1-dev libvorbis-dev
When installing using bzr files previous you have to install some dependencies before (tested on lenny), use dpkg -l |grep libboost to check that previous version is not installed, if is installed remove all packets that shows the output of dpkg -l |grep liboost
# apt-get install libboost-serialization1.35-dev libboost1.35-dev libsigc++-2.0-dev
then continue with the following installation (first check that file configure.ac has commented this line: PACKAGE_DATA_DIR="./data")
# autoreconf
# ./configure
# make
and then run the program simply typing psynth3d, if the program gives you the output: [/alsa] WARNING: Could not write to device. (Broken pipe) change the audio to oss in config menu.
Installing
If you downloaded the program from Bazaar you will first need to generate the compilation scripts:
autoreconf
Now you will need to run the configuration script to detect the the libraries and set up the compilation settings.
./configure
Check that everything has been detected correctly and then compile the program:
make
At last we must run these commands with superuser privileges to install:
make install ldconfig
We can now run the 3D simulator:
psynth3d
